swing about

英

美

[网络] 摆动

网络

双语例句

• The authors gave 3D design and virtual manufacture about center gear of swing oscillating tooth drive based on Pro/ NC, solved manufacture problems about complex flank profile of center gear. the exploit period are shortened remarkably of swing oscillating tooth reducing device.
  文中基于Pro/NC给出了摆动活齿传动的主要零件&中心齿轮的3D设计及虚拟加工，解决了中心齿轮复杂齿廓加工问题，显著缩短了摆动活齿减速器产品的开发周期。
• Especially today, as the "new countryside" in the country in full swing. The old problem has become a new focus, concerned about by many people.
  尤其在今天，随着新农村建设工作在全国范围内的全面展开，学术层面的老难题又成为了社会层面的新焦点，被社会各方面所关注。
• There is, however, an upper limit on the voltage that can be applied where you can no longer bias for symmetrical swing about the idle point without exceeding the plate dissipation ratings.
  但是，有一个上限的电压，可套用在这里您可以不再为对称摆动偏见的闲置点不超过板耗散评级。
• Optimization result shows that the aluminum alloy swing arm meets the conditions under strength and stiffness required in the circumstances, and the weight is reduced about 12.23% with respect to the steel one.
  优化结果表明，铝合金下横臂在满足各工况下强度和刚度要求的情况下，摆臂的重量相对于铸钢材料降低约12.23%。
• If you've dealt with Swing for a while now, I'm sure you first thought about performance issues.
  如果您使用Swing已经有一段时间，那么我可以肯定，您首先想到的是性能问题。
• According to this calculation, the swing speed is about 11 per cent higher than that in the reference [ 1].
  按此计算公式计算的回转速度约比文献[1]的计算公式所得的相应值高11%。
• At the same time, science and technology is rapidly developed and information construction is carried out in full swing in all fields. Colleges and universities are also increasingly concerned about the information construction as well.
  同时，科学技术水平急速发展以及信息化建设在各大行业开展的如火如荼，高校也对信息化建设愈加关注。
• If any DHTML scripts are involved, forget about it& the existing Swing components can't display it.
  如果包含任何DHTML脚本，那么请忘记它&现有的Swing组件不能显示它。
• In order to improve the sensitivity of the low-voltage impedance and avoid mal-operating in the system swing, it gives a new criterion about generator low-voltage impedance.
  为了提高发电机电势降低判据的灵敏度，防止系统振荡造成的误动作，提出了发电机低电势判据。
• The forming technology of the support rack and the structure of the notching die were introduced. The working process of simultaneously shearing four notches through the punch's level swing about was presented as well.
  介绍了托架成形工艺及切口模结构及切口凸模通过水平左右摆动同时切出4个缺口的工作过程。